0 Replies Latest reply: Mar 1, 2012 8:55 AM by user13013089 RSS

    How do I configure STK6140 + JBOD CSM200

    user13013089
      I have 6140 and CSM200

      I confused with expansion tray connection:

      I connected according to Hardware instalation guide 819-7497-11:

      1. Locate the Controller A and Controller B expansion ports at the back of the controller tray (FIGURE 2-31).
      2. Locate expansion ports 1A (In) and 1B (Out) at the A-side and B-side back of the expansion tray (FIGURE 2-31).
      3. Connect one FC cable between the Controller B channel 1 expansion port and the B-side port 1B of the expansion tray (FIGURE 2-32).
      4. Connect one FC cable between the Controller A channel 1 expansion port and the A-side port 1B of the expansion tray (FIGURE 2-32).

      In this configuration, the following expansion ports are not used:

      Controller B channel 2 expansion port
      Controller A channel 2 expansion port

      A-side controller expansion port 1A of the expansion tray
      B-side controller expansion port 1A of the expansion tray


      But in Service Advisor:

      Connect one FC cable from the controller "A" channel 1 expansion port of the controller tray, to the IOM "A" port 1A of the expansion tray.
      Connect one FC cable from the controller "B" channel 1 expansion port of the controller tray, to the IOM "B" port 1A of the expansion tray.

      Edited by: user13013089 on Mar 1, 2012 6:22 AM