Hello, I have a Sun Netra 240 server box that on every power up runs the max level POST which takes a good 5 minutes to complete. I have the power key switch set to the normal position and not DIAG mode and I have the Diag-level set to "off" for the system configuration settings. Nothing gets reported as an error during the POST but it still continues to run full POST on every power cycle. Can anyone tell me what else to check or look at to make it stop? Thanks in advance.
I have no way to get a copy of this from the screen so I had to write it all down and hand jam it in. I only put my values, not the default values. These have not been changed though so I don't think it is any of these settings. Just for some background this server has been fine for the past year or so and then one day it just started doing this out of the blue.
ttyb mode 9600,8,n,1,-
ttya mode 9600,8,n,1,-
load base 16384
security mode command
NVRAMRC devalias radbkup
Edited by: 941057 on Jun 15, 2012 2:38 PM