1 Reply Latest reply: Sep 29, 2012 12:39 AM by Kalyan Pasupuleti-Oracle RSS

    SELinux and Weblogic

    paguas
      Does there exist anywhere information to build a Weblogic server on Security Enhanced Linux?
        • 1. Re: SELinux and Weblogic
          Kalyan Pasupuleti-Oracle
          Hi,


          Check this steps.


          Oracle Fusion Middleware products are supported on SELinux(Security Enhanced Linux) but with permissive mode.

          To setup SELinux into permissive mode, please run the following command.

          # setenforce 0 (will require privileged access)

          # setenforce 0 only changes the mode of SELINUX and does not disables it.

          For disabling we need to change the file config under “/etc/selinux”:

          # This file controls the state of SELinux on the system.

          # SELINUX= can take one of these three values:

          # enforcing - SELinux security policy is enforced.

          # permissive - SELinux prints warnings instead of enforcing.

          # disabled - SELinux is fully disabled.

          SELINUX=disabled

          # SELINUXTYPE= type of policy in use. Possible values are:

          # targeted - Only targeted network daemons are protected.

          # strict - Full SELinux protection.

          SELINUXTYPE=targeted

          Make SELINUX=enforcing or permissive. or diabled to disable the SELinux.



          Regards,
          Kal