This discussion is archived
6 Replies Latest reply: Nov 15, 2012 6:29 AM by 973620 RSS

Selecting applet calls powerdown() mode and it terminates

973620 Newbie
Currently Being Moderated
Dear All,

I am running a Java Card applet on Eclipse. I am using JCWDE to run/debug it. When I select the applet it is selected and then it goes into powerdown state which causes the program to terminate and stop the application. My sequence of steps and log is below.


//====================Log==================
jcwde is listening for T=0 Apdu's on TCP/IP port 9,025.

powerup();
O: 0x00 0xA4 0x04 0x00 0x0b 0x01 0x02 0x03 0x04 0x05 0x06 0x07 0x08 0x09 0x00 0x00 0x7F
Status: 9000
powerdown();

jcwde exiting on receipt of power down command.
//========================================

Can any one help that why my applet terminates, why do I go in powerdown mode, what is powerdown mode?

Thank you so much,

Best Regards,
Naveed

Legend

  • Correct Answers - 10 points
  • Helpful Answers - 5 points