2 Replies Latest reply: Dec 7, 2012 12:40 PM by LaserSoft RSS

    Oracle RAC IP Configuration

    971394
      Hi all
      How to configure IP,Subnet,Gateway for Oracle RAC in Linux.?
        • 1. Re: Oracle RAC IP Configuration
          hitgon
          http://arjudba.blogspot.in/2008/08/configure-network-for-oracle-rac.html

          Refer the Oracle document
          http://docs.oracle.com/cd/B28359_01/rac.111/b28252/preparing.htm#CEGEEEGI
          • 2. Re: Oracle RAC IP Configuration
            LaserSoft
            Hi Friend,

            Thumb Rules :

            1. All public NICs must have the same name on all nodes in the cluster
            2. Similarly, all private NICs must also have the same names on all nodes

            Use component verifications commands like 'nodereach' or 'nodecon' for this purpose. Type cluvfy comp -help on the command prompt. If the 'cluvfy comp nodecon' command is invoked without -i, cluvfy will attempt to discover all the available interfaces and the corresponding IP address & subnet. Then cluvfy will try to verify the node connectivity per subnet.

            You can run this command in verbose mode to find out the mappings between the interfaces, IP addresses and subnets. You can check the connectivity among the nodes by specifying the interface name(s) through -i argument

            Note : If you metalink support, there is a step by step document *RAC and Oracle Clusterware Best Practices and Starter Kit (Linux) [ID 811306.1]*

            Thanks
            LaserSoft