This content has been marked as final. Show 2 replies
The configuration type (A, B1, B4) is set during the pre-personalization of card.
If you want to know the pre-personalization commands for that chip you should to get the full datasheet (under NDA) from NXP. And you should to get the transport key from vendor of your card.
If your card was pre-personalized you can't change the configuration type.
Edited by: Lyolik on 30.12.2012 7:45
That's not quite correct. Supported MF emulation on NXP JCOP/SMX is chosen during production, it cannot be set during pre-perso.