2 Replies Latest reply: Jan 31, 2013 7:06 PM by 986572 RSS

    prtdiag -v says PS_FAULT steady but no prolem

    986572
      Hi,

      Does anyone know the way to clear the status of "PS_FAULT steady" by
      prtidiag -v command on Solaris 10 ?

      LEDs:
      ------------------------------------------------------------
      Location LED State
      ------------------------------------------------------------
      SYS SERVICE off
      SYS LOCATE off
      SYS ACT steady
      SYS PS_FAULT steady <-- Here !
      SYS TEMP_FAULT off
      SYS FAN_FAULT off

      As PowerSupply was already replaced to new one and the problem was fixed,
      and showenvironment command by alom says OK and no fault exists as the follows,,,

      --------------------------------------------------------------------------------
      Power Supplies:
      --------------------------------------------------------------------------------
      Supply Status Fan_Fault Temp_Fault Volt_Fault Cur_Fault
      --------------------------------------------------------------------------------
      /SYS/PS0 OK OFF OFF OFF OFF
      /SYS/PS1 OK OFF OFF OFF OFF


      The way without rebooting system is appreciated.
      Waiting for your news !

      Dai.