This discussion is archived
2 Replies Latest reply: Feb 13, 2013 1:09 PM by 856968 RSS

write error on vbox and linux 4

856968 Newbie
Currently Being Moderated
my database can not update in a linux86 host on window64's vbox,
dmesg as
MSI INIT SUCCESS
PCI: Setting latency timer of device 0000:00:0d.0 to 64
ahci 0000:00:0d.0: AHCI 0001.0100 32 slots 1 ports 3 Gbps 0x1 impl SATA mode
ahci 0000:00:0d.0: flags: 64bit ncq stag only
ata1: SATA max UDMA/133 cmd 0xF8824100 ctl 0x0 bmdma 0x0 irq 5
scsi0 : ahci
ata1: SATA link up 3.0 Gbps (SStatus 123 SControl 300)
ata1.00: ATA-6, max UDMA/133, 1048529408 sectors: LBA48 NCQ (depth 31/32)
ata1.00: ata1: dev 0 multi count 128
ata1.00: configured for UDMA/133
Vendor: ATA Model: VBOX HARDDISK Rev: 1.0
Type: Direct-Access ANSI SCSI revision: 05
SCSI device sda: 1048529408 512-byte hdwr sectors (536847 MB)
SCSI device sda: drive cache: write back
SCSI device sda: 1048529408 512-byte hdwr sectors (536847 MB)
SCSI device sda: drive cache: write back
sda: sda1 sda2
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
device-mapper: 4.5.5-ioctl (2006-12-01) initialised: dm-devel@redhat.com
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
SELinux: Disabled at runtime.
SELinux: Unregistering netfilter hooks
inserting floppy driver for 2.6.9-103.0.0.0.1.EL
floppy0: no floppy controllers found
Intel(R) PRO/1000 Network Driver - version 7.3.20-k3-NAPI
Copyright (c) 1999-2006 Intel Corporation.
ACPI: PCI Interrupt 0000:00:03.0[A] -> GSI 10 (level, low) -> IRQ 10
PCI: Setting latency timer of device 0000:00:03.0 to 64
e1000: 0000:00:03.0: e1000_validate_option: Flow Control Receive Only
e1000: 0000:00:03.0: e1000_probe: (PCI:33MHz:32-bit) 08:00:27:03:19:c5
divert: allocating divert_blk for eth0
e1000: eth0: e1000_probe: Intel(R) PRO/1000 Network Connection
ACPI: PCI Interrupt 0000:00:05.0[A] -> GSI 5 (level, low) -> IRQ 5
PCI: Setting latency timer of device 0000:00:05.0 to 64
intel8x0_measure_ac97_clock: measured 138453 usecs
intel8x0: measured clock 12170 rejected
intel8x0: clocking to 48000
ACPI: PCI Interrupt 0000:00:04.0[A] -> GSI 9 (level, low) -> IRQ 9
vboxguest: major 0, IRQ 9, I/O port d020, MMIO at 00000000f0400000 (size 0x400000)
vboxguest: Successfully loaded version 4.2.6 (interface 0x00010004)
ohci_hcd: 2004 Feb 02 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
ACPI: PCI Interrupt 0000:00:06.0[A] -> GSI 11 (level, low) -> IRQ 11
ohci_hcd 0000:00:06.0: OHCI Host Controller
PCI: Setting latency timer of device 0000:00:06.0 to 64
ohci_hcd 0000:00:06.0: irq 11, pci mem f883c000
ohci_hcd 0000:00:06.0: new USB bus registered, assigned bus number 1
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 8 ports detected
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET: Registered protocol family 10
Disabled Privacy Extensions on device c0392360(lo)
IPv6 over IPv4 tunneling driver
divert: not allocating divert_blk for non-ethernet device sit0
mtrr: your processor doesn't support write-combining
mtrr: your processor doesn't support write-combining
mtrr: your processor doesn't support write-combining
ACPI: AC Adapter [AC] (off-line)
ACPI: Battery Slot [BAT0] (battery present)
ACPI: Power Button (FF) [PWRF]
ACPI: Sleep Button (FF) [SLPF]
EXT3 FS on dm-0, internal journal
loop: loaded (max 8 devices)
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda1, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
Adding 5668856k swap on /dev/VolGroup00/LogVol01. Priority:-1 extents:1
IA-32 Microcode Update Driver: v1.14 <tigran@veritas.com>
microcode: No new microdata for cpu 0
IA-32 Microcode Update Driver v1.14 unregistered
ip_tables: (C) 2000-2002 Netfilter core team
ip_tables: (C) 2000-2002 Netfilter core team
ADDRCONF(NETDEV_UP): eth0: link is not ready
e1000: eth0: e1000_watchdog_task: NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX
ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
i2c /dev entries driver
vboxsf: no version for "VBoxGuest_RTMemTmpFree" found: kernel tainted.
vboxsf: Successfully loaded version 4.2.6 (interface 0x00010004)
eth0: no IPv6 routers present
lp: driver loaded but no devices found
mtrr: your processor doesn't support write-combining
mtrr: your processor doesn't support write-combining
mtrr: your processor doesn't support write-combining
ISO 9660 Extensions: Microsoft Joliet Level 3
ISO 9660 Extensions: RRIP_1991A
SCSI error : <0 0 0 0> return code = 0x6000000
end_request: I/O error, dev sda, sector 589254333
Buffer I/O error on device dm-0, logical block 73630638


Any idea?
thanks

Legend

  • Correct Answers - 10 points
  • Helpful Answers - 5 points