3 Replies Latest reply on May 27, 2013 4:24 PM by 1011216

    2 vsw on one interface?

      My configuration
      T4-4 with Control Domain PRIMARY (pci_0, pci_2) and IO domain SECONDARY (pci_1, pci_3)

      On both domain I'd like to create two VSW (public, private) on one interface.
      No problem to create it on on primary domain, I have got two switches on net0
      But I cant create two vsw on secondary domain when i create second one it says
      # ldm add-vsw net-dev=net0 secondary-public-vsw0 secondary
      # ldm add-vsw net-dev=net0 secondary-private-vsw0 secondary
      The device net0 for virtual switch secondary-private-vsw0
      is already in use by virtual switch secondary-public-vsw0
      any ideas?

      Edited by: 987922 on 2013-02-13 13:24
        • 1. Re: 2 vsw on one interface?
          Bjoern Rost
          Can you manually create two vnics and then the vsw after that like this:
          dladm create-vnic -l net0 vnic0
          dladm create-vnic -l net0 vnic1
          ldm add-vsw net-dev=vnic0 secondary-public-vsw0 secondary
          ldm add-vsw net-dev=vnic1 secondary-private-vsw0 secondary
          I have not tried it with your exact setup (in an io domain) but I am fairly confident that this should work. Then again, I would have expected this to work equally in the global and storage domain

          1 person found this helpful
          • 2. Re: 2 vsw on one interface?
            yes, it works! when i create two vnic on my aggregation i can create two vsw :)

            • 3. Re: 2 vsw on one interface?
              You may be able to create LDoms vsws on vnics created with dladm command, but a vsw won't function on a vnic. An LDoms vsw requires a GLDv3 device such as a physical NIC or aggr, to be able to configure mac-addresses, vlans and other information for each vnet, where as a VNIC is a meta device only.