I have a sun server SunOS PNR1RAD01 5.10 Generic_144488-09 sun4v sparc SUNW,Netra-T5220 where i have an interface e100g0.
This was earlier in running state but now this doesnt show running state. I tried to reset the interface, checked the cable but it did not help.
Can nyone pls help me on this.
e1000g0: flags=1000803<UP,BROADCAST,MULTICAST,IPv4> mtu 1500 index 2
inet 10.200.2.73 netmask fffffff8 broadcast 10.200.2.79
Please show content of the file:
RUNNING Indicates that the system is transmitting packets through the interface. man ifconfgi
-xmit Disable transmission of packets on an interface. The
interface will continue to receive packets.
Try use command: ifconfig e1000g0 xmit
Some time snoop -d e1000g0 can help resolve problem
Snoop can show present or not some other packets on network.
According dladm output it's look like physical problems ( link not ptresent).
Can you check LED's status on server, port status on switch, change ethernet cable, port on switch?
Cross-posted to another forum web site:
You could have been considerate and have had the manners to let everyone know. Then they would spend time or effort duplicating what you may have been already told elsewhere.
There have been no changes made on the switch level, nor do i suspect anything on the port & cable as the ip defined on this interface is well reachable from another server.
I there any way to reset this interface as the link state shows down in the below o/p:
root@PNR1RAD01 # dladm show-dev
**e1000g0 link: down speed: 0 Mbps duplex: half**
e1000g1 link: up speed: 1000 Mbps duplex: full
e1000g2 link: unknown speed: 0 Mbps duplex: half
e1000g3 link: unknown speed: 0 Mbps duplex: half
Hi. e1000g0 link: down speed: 0 Mbps duplex: half
and * ip defined on this interface is well reachable from another server ip defined on this interface is well reachable from another server* more like as conflict IP address.
Check arp table on another server and compare MAC address on e1000g0.
Your problem is in the /etc/hosts file. You have set the same name PNR1RAD01 to both interfaces e1000g0 and e1000g1
the correct configuration should be:
ossuser@PNR1RAD01 # cat hostname.e1000g0
ossuser@PNR1RAD01 # cat hostname.e1000g1
root@PNR1RAD01 # cat /etc/hosts
# Internet host table
10.200.2.73 PNR1RAD01 loghost
Reboot the machine for the changes to take effect and then check the status of the interface (ifconfig -a)