Go Directly To
Oracle Technology Network Community
My Oracle Support Community
OPN Cloud Connection
Oracle Employee Community
Oracle User Group Community
OTN Speaker Bureau
Get Started Guide
Join the world’s largest interactive community dedicated to Oracle technologies.
Learn from thousands of community experts
Get answers to your technical questions
Share your knowledge with peers
Please enter a title.
You can not post a blank message. Please type your message and try again.
This discussion is archived
on Apr 6, 2013 9:47 AM by fxmatz
Install MV ps6 problem
Apr 5, 2013 10:04 PM
I installed MV 188.8.131.52 on WLS 10.3.5.6 Win7 64 and the MV is running.
Then I conifigured the .. map_data_source name="mvdemo" .. but I can not see the +"Existing data source"+ in "*Datasouces*" .
A JDBC Oracle XA connect on the mvdemo schema runs fine on this WLS.
Is there a tip to configure this datasource in WLS-MapViewer ?
Thanks and regards
I have the same question
Show 0 Likes
This content has been marked as final.
Show 1 reply
Re: Install MV ps6 problem
Apr 6, 2013 9:47 AM
in response to
after new start of the WLS and MapViewer the datasource mvdemo exists now :-) .
I think that I pressed "Save&Restart" in the Configuration Section ..