This content has been marked as final. Show 6 replies
Sounds like you are doing most of it correctly. Two hints thou:
- Can you trap the socket xml message to see if it is missing there? If it is, the sender is the problem
- When you put the xml in the data, did you escape the xml tags first ( like replace all < with <, etc)
If you couldn't get any further, I can post a remotedriver test client, that will just dump out the messages.
Thx -- Sam
the supplied XML-Data looks like this:
So it seems like the Data-Segment is missing. I didn't use this time no xml in the Data-Field so <, isn't the problem.
The Edg-Utl. Command looks like this:
call Edg_utl.sendtoedge (101, 0,'myItemID' ,'BHG', 'ProductionLineDevice', 'MY_TESTDATA', sysdate,'src','cor');
So maybe we should try the remote-Driver test-client
I have configured the remote driver to listen a port where the event data is published.(<event> </event>)
I need to read this data from the port and forward to a oracle table after processing. Can remote driver listen to the port and display in the edge server "monitor event" ? From there I will also set up a rule to forward to a particular location.
Is Remote Driver the right one to do this job or I have understood anything completely wrong?? Kindly help.
After setting the remote driver, there is no error message/events shown in monitor events. Should I customise the code to do this job?? If customisation is needed, can you direct me to any documents to help get started.