This content has been marked as final. Show 2 replies
There is functionality in the Configure To Order process called "CTO Matching". In this scenario, during the Autocreate process, the system will check to see if the same item has already been created. If so, they system will re-use that item rather than create a new item. To turn this functionality on, you would set the following profiles:
BOM: Match to Existing Configurations = Yes
As you state, there are options that can control the matching functionality on a model-by-model basis. You will need the above profile set to Yes in order for the item-specific matching attributes to be applicable. There are many details regarding the matching functionality in the Configure To Order Process Guide.
In addition, you specific example will never match as you intend. During the AutoCreate Configuration Items process, the system looks for a matching configuration. The problem is that the match procedure is not actually looking at the actual bill of material. It is looking at a table called BOM_ATO_CONFIGURATIONS. This table is loaded when the original configuration item was created.
In your case, BOM_ATO_CONFIGURATIONS was loaded with options 1 and 2. When you manually added option 3 to the BOM, the BOM_ATO_CONFIGURATIONS table is not updated to reflect this change. So when you take a configuration for options 1, 2, and 3...a new configuration item will be generated. There is no front-end form for you to maintain the BOM_ATO_CONFIGURATIONS table.