This content has been marked as final. Show 6 replies
I also have this problem on our M9000. And I have set and enabled the SNMP then set and enable SunMC, but the Agent status is still "Enabled,Stopped". Please refer to below information and check what's wrong for me, thanks a lot.
XSCF> setsunmc disable
setsunmc: Agent disabled.
setsunmc: Note that this command will return before SunMC is completely disabled.
XSCF> setsnmp disable
setsnmp: Agent disabled.
XSCF> setsnmp enable
setsnmp: Agent enabled.
XSCF> setsunmc enable
setsunmc: Agent enabled.
setsunmc: Note that this command will return before SunMC is completely enabled.
Agent Status: Enabled
Agent Port: 161
System Description: SMP HPC of SPARC Enterprise M9000-64
Hostname Port Type Community String Username Auth Protocol
192.168.1.100 162 v2 public n/a n/a
Community String: public
Enabled MIB Modules:
Agent Status: Enabled, stopped
Setup Status: Set up
SunMC Server: 192.168.1.100
Security Seed: 1211
SNMPv1 Community String: public
Agent Port: 1161
Host Trap Port: 162
Host Event Port: 163
SNMP Agent Port: 161
Domain Agent Port: 8161
Edited by: Yu-Hung on Apr 1, 2008 12:31 AM
Edited by: Yu-Hung on Apr 1, 2008 12:35 AM
I just came across this thread and have encountered this issue before.
Check to see if a name server is set with a "shownameserver" - or use "setnameserver" to set one. Use the man pages for specific syntax use. ie "man setnameserver"
There is a requirement to have the nameserver set on the XSCF or the SunMC agent will not start.
Hope this helps,