Forum Stats

  • 3,874,212 Users
  • 2,266,682 Discussions
  • 7,911,769 Comments

Discussions

No network Interface on Ultra-45

807557
807557 Member Posts: 35,835
edited Dec 14, 2008 3:43PM in Workstations General Discussion
Hi,
How to check the netwrok interface on Ultra-45.
There is no information regarding it in /etc/path_to_inst or #kstat -c net |grep net.
The output of 'ifconfig' command showing loob back interface.

Comments

  • 807557
    807557 Member Posts: 35,835
    The built in network interfaces for this system should be bge0 and bge1.
  • 807557
    807557 Member Posts: 35,835
    edited Dec 14, 2008 3:43PM
    Hi,

    # ifconfig -a
    lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232 index 1
    inet 127.0.0.1 netmask ff000000
    bge1: flags=1004843<UP,BROADCAST,RUNNING,MULTICAST,DHCP,IPv4> mtu 1500 index 2
    inet 192.168.0.3 netmask ffffff00 broadcast 192.168.0.255
    ether 0:14:4f:c3:20:a5
    lo0: flags=2002000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv6,VIRTUAL> mtu 8252 index 1
    inet6 ::1/128
    bge1: flags=2000841<UP,RUNNING,MULTICAST,IPv6> mtu 1480 index 2
    inet6 fe80::214:4fff:fec3:20a5/10
    ether 0:14:4f:c3:20:a5
    bge1:1: flags=2080841<UP,RUNNING,MULTICAST,ADDRCONF,IPv6> mtu 1480 index 2
    inet6 2a01:e35:2e10:640:214:4fff:fec3:20a5/64
    #


    - For a reason i never understand, the first used interface must be bge1, i.e. the bottom RJ45 interface.

    Sergio

    Edited by: COCHEDELAFERTE on Dec 14, 2008 8:43 PM
This discussion has been closed.