Forum Stats

  • 3,876,221 Users
  • 2,267,082 Discussions
  • 7,912,474 Comments

Discussions

Carrying out Golden Gate REPLICAT without datapump / extract running

785756
785756 Member Posts: 9
edited Apr 12, 2011 5:23PM in GoldenGate
Hi - Would appreciate some advise on this

I've got the following scenario
Source - Extract stopped / Datapump stopped
Destination - Replicate running

Basically on some prior day, Extract / datapump was run on Source to extract N amount of trail files & transfer these to the destination.
At this point, on the source Extract / Datapump are stopped.

Is there any way to enforce the Replicate to load these trail files (either continue or load from start) ?
... I had a search of parameter entries but there doesn't seem to be a way make Replicate happen unless Extract / Datapump on source are running.

Thanks.

Answers

This discussion has been closed.