The server has quad interface...
# dladm show-dev
e1000g0 link: up speed: 1000 Mbps duplex: full
e1000g1 link: unknown speed: 0 Mbps duplex: half
e1000g2 link: unknown speed: 0 Mbps duplex: half
e1000g3 link: unknown speed: 0 Mbps duplex: half
There is a network cable plugged in e1000g3 with a status light. I have verified the cable is good by swapping cables with e1000g0. I am unable to get the nic to respond. If i do a:
#ifconfig e1000g3 plumb
The dladm show-dev command will then show the interface as speed:1000 Mbps and duplex:full but the link will still be unknown.
I have change some settings in e1000g.conf just to see if there would be any affect and it was not. I change duplex settings to be all 47 in e1000g.conf.