here is the command.
crs -4563:Insufficient user privilges crs-4000 command stop failed or completed with errors.
nisha wrote:In Pre Oracle 11gR2 there are seperate init script of each component like
thanks for reply i tried to start as a root user
but it is throughing error.
-bash command not found.
i tired this command .please help me out.thanks
# crsctl start crs.
nisha wrote:check your network settings and able to ping , ssh without password between two machines.
these all are for learning purpose i am not working anywhere i am University student
and i tired to learn this but unfortunatlly i am not succeeded
i have laptop thoshiba Qosmio i5 processor and 8Gb Ram
i have installed VMware and there i have Installed oracle linux 5 uptade 4 on both nodes
Yesterday it was working fine but when i switch on laptop today
so i got all these error
ssh error corrupt on both nodes.
and crs was not working
all these error i got.
if there is any other way to do it plz suggest me
i will install fresh os(linux) and i will try
i followed the following link.
maybe possible there will be better tips than that.
if yes plz share with me.
please guide me where i can find ntpd.pid file because search for it ,i did not find.
Either configure NTP, or make sure it is not configured so the Oracle Cluster Time Synchronization Service (ctssd) can synchronize the times of the RAC nodes. In this case we will deconfigure NTP. # service ntpd stop Shutting down ntpd: [ OK ] # chkconfig ntpd off # mv /etc/ntp.conf /etc/ntp.conf.org # rm /var/run/ntpd.pid