This content has been marked as final. Show 2 replies
This can be done with JET
You create the template as normal.
Then create a profile file with the slice 7 line.
Then edit the template to use it.
# It is also possible to append additional profile information to the JET
# derived one. Do this using the base_config_profile_append variable, but
# don't forget to fill out the remaining base_config_profile variables.
It is how OpsCentre (which uses JET) does it.
JET questions are best asked on the external JET alias at yahoogorups (until the forum is setup on OTN)