This content has been marked as final. Show 8 replies
Make sure that you've gone through the readme a few times for the patch so that you know what to expect. You most likely will be able to use "opatch auto" assuming that all the homes are 22.214.171.124, and that you want to patch them all in one shot. Make sure that you create your OCM response file before starting the patch ($ORACLE_HOME/OPatch/ocm/bin/emocmrsp).1 person found this helpful
I'd check through the supported versions note (888828.1) to cross-reference the storage server version (imageinfo) against the bundle patch version to make sure that you aren't getting one patch type (bundle patch) too far from the version of the storage server (exadata storage server patch).
I'd strongly suggest considering the Oplan out-of-place patching method. See note 1306814.1 for Oplan details.1 person found this helpful
I also hope you had a typo - no one should be installing 126.96.36.199 BP3 at this point. BP11 was released last week, so there are at least 8 better choices than BP3 available. You should consider installing the current release or something close to it at least.
There are currently no dependencies between BPs and Exadata versions, but if you're upgrading/patching the environment, it is a good idea to stay current on Exadata software as well. As Andy mentioned, note 888828.1 has all the info and links to some other notes that will be helpful too.
Thank you for your replies!
I will go through the mentioned support notes.
Yes, it was a typo, i meant PSU 3 not bundle 3.
I have a follow-up question:
How do i determine the exadata storage server software version?
Thanks a lot!
Oracle makes Exadata-specific bundle patches for the database software rather than PSU patches. The bundle patches contain many of the same fixes as PSU's, but are released more often and contain Exadata-specific bugfixes. My Oracle Support note 888828.1 lists the most current release of each type of Exadata-related patch (not just database bundle patches, but storage server software and firmware for various hardware components).
To see storage server software version, log into the storage server and run "imageinfo"
Hope this helps!
Let's see if I got this right:
When dealing with exadata i should forget all about GI+DB PSU's (latest one being PSU 3 - 188.8.131.52.3) which I'm used to, and only apply the BP 11 for GI&DB as noted as current in 888828.1?
Thanks a lot!
That's correct....on Exadata, PSUs are released through bundle patches. I'd advise that if this is a production system and you don't have anywhere to test, I'd not go straight to BP11, as it's been out for less than a week. I've found that it's best to stay a little behind the cutting edge with regard to Exadata. Even Oracle recommends to stay back a little bit, unless you have to. From the supported versions note (888828.1):
+A patch should be installed on a production system only after it has been validated in a proper test environment, and no less than one month after release to allow field experience to solidify.+
I can't stress enough how important it is on Exadata to test patches thoroughly before applying them into production environments.
Thank you all for being so helpful! Really appricated! :)