This content has been marked as final. Show 3 replies
Hi.1 person found this helpful
What command ( show full command line) you use for set boot device ?
General, for setting boot device on SPARC platform use Solaris command: eeprom boot-device=net
Or OBP command: setenv boot-device net
set /HOST/bootmode script="setenv boot-device net"
Edited by: Nik on 05.12.2011 22:40
The host machine is Sparc Sun T3. It is not x86 hardware.
Ideally I would like to use ipmitool to change the boot device. The commands I am running are the following:
ipmitool -I lanplus -H xxx.xxx.xxx.xxx -U root -P tom chassis bootdev pxe clear-cmos=yes
ipmitool -I lanplus -H xxx.xxx.xxx.xxx -U root -P tom chassis bootparam set bootflag force_pxe
Both commands run to successful but no effect on changing the boot device.
I tried with obp command and SP command like you mentioned below, both are not change the boot order. Not tired eeprom yet.
ideally i want to write a shell script which when run would connect to ilom of Sun T3 Sparc and run change the boot device.
Edited by: 900765 on Dec 6, 2011 2:39 PM
Using obp, I am able to change the boot device to net. The command I used is "setenv boot-device net"
Now the interesting part it is needed to issue this command for the changes to take effect. Type "reset-all". I could clearly see that the boot order is changed and the system starts booting from the net.
I want to do something like this just using ipmitool. Where I run the command and set the boot device and run a command similar to reset-all?
Secondly using ilom for sp, i still do not have procedure that works. Remmember, it allows to change the boot order but it just don't work.