4 Replies Latest reply: Feb 4, 2012 1:29 AM by 914631 RSS

    SUN T5120

      We lost Ilom via the 'u-boot erase all' command.
      How can we recover ilom ?
        • 1. Re: SUN T5120
          It's not exactly your system, but read:

          What reason do 'u-boot erase all' ?

          • 2. Re: SUN T5120

            Thanks for your answer.
            We got a T5120 server for lab purpose (end of support), but the ILOM password was not known.
            At the moment nobody can tell me howto startup the ILOM software from the beginning with the initial password 'changeme'.

            Can you answer this question?
            • 3. Re: SUN T5120
              To reset a lost ILOM password on a T5120, you need to put a jumper to connect pins 1 and 2 of J6801 on the motherboard. The J6801 you want is near the very back, middle of the jumper card right next to where the middle PCIe card would go. I've had to do this several times.
              • 4. Re: SUN T5120

                u-boot erase all command removes the ILOM software.
                The u-boot should still work and via a tftp server we can load the ILom software again.

                After the "erase all" command, I don't get a reaction on the serial  console. I suppose the serial parameters are changed?
                I shall start the procedure from the info you send me.