May everyone help me?
Now I had the problem with the vdisk in fail status because of two disks were fault at the same time. This vdisk was config with RAID Level 5 with 7 x 300GB disks.
After we replaced the the two disk fail, that disk is within the unsigned status. Thus we need to assign that two disks replaced back to the old vdisk.
We are already tried with sscs revive command the that vdisk but it show us with array is not support then we found that array firmware version 7.x is not support the revive option.
May anyone guide us within this issue?
Thanks you in advance.
You have RAID-5 and have failed 2 disk so you lost a data.
You should delete all volumes on this vdisk and this vdisk.
And recreate all required volumes on new vdisk.
Data you should restore from backup.