6 Replies Latest reply on Sep 13, 2012 1:25 PM by Tom B-Oracle

    How to Configure Selector For JMS Bridge

    vv*338251*hu
      Hi,

      I was trying with Selector option in working with multiple Bridges, here is the scenario i applied.

      Created five Queues ( Q1, Q2, Q3, Q4 and Q5 ) and configured JMS Bridge Destinations having each queue with unique connection factory ( CF1, CF2, CF3, CF4 and CF5 ) and named it as D1, D2, D3, D4 and D5.
      Then created JMS Bridges as JB2 with source as D1 and destination as D2. Similarly JB3 as D1-D3, JB4 as D1-D4 and JB5 as D1-D5.
      And set Sector for each of JB2, JB3, JB4 and JB5 as Two, Three, Four and Five respectively and did restart after the changes.

      Now i am expecting the following scenario to work
      Pushing message to Q1/CF1 having Two in the content of message, hence expecting the message to be delivered to Q2/CF2 through JB2, but the messages is not moved through JB2.
      Similarly, Pushed message to Q1/CF1 having Three in the content of message, hence expecting the message to be delivered to Q3/CF3 through JB3, but the messages is not moved through JB3. Similar behavior for other messages having Four and Five in the message content.

      During the bridge configuration, selected QOS as "Atmost-Once".

      Note: All the configurations were done in same domain and the WL version is 10.3.6.0.*

      The sample message i am pushing to Q1/CF1 say "Two Test Data"* and expecting to reach Queue Q2/CF2

      Regards
      Venkata Madhu

      Edited by: vv**** on Sep 12, 2012 1:05 PM