1 Reply Latest reply: Sep 21, 2012 12:57 PM by user6042081 RSS

    root.sh get stuck at Using configuration file .......crsconfig_params

    751811
      Hi all I am trying to install Oracle RAC 11g2 (11.2.0.3) on Redhat 5.8 (64 bit)

      Kernel version is 2.6.18-308.1.1.e15

      Disks are presented using UDEV to ASM

      in node 1 the root.sh will run with out any issue, but on node2 it gos as far as the message

      "Using configuration parameter file: /home/oragi/11.2.0.3/grid/crs/install/crsconfig_params"

      I have set the "set -x" still it goes up to above message and stops, no errors, no wornings. I have googled but without any luck

      Thanks and Regards

      Edited by: user4433949 on Sep 21, 2012 12:08 AM

      Edited by: user4433949 on Sep 21, 2012 12:08 AM
        • 1. Re: root.sh get stuck at Using configuration file .......crsconfig_params
          user6042081
          Hi since then I have made some progress, I deinstall and redid the RAC root.sh on Node1 runs through with out any issue, though Firewall is off on both nodes and privot ips are pingable on Node2 I get below

          Creating OCR keys for user 'root', privgrp 'root'..
          Operation successful.
          OLR initialization - successful
          Adding daemon to inittab
          ACFS-9200: Supported
          ACFS-9300: ADVM/ACFS distribution files found.
          ACFS-9307: Installing requested ADVM/ACFS software.
          ACFS-9308: Loading installed ADVM/ACFS drivers.
          ACFS-9321: Creating udev for ADVM/ACFS.
          ACFS-9323: Creating module dependencies - this may take some time.
          ACFS-9327: Verifying ADVM/ACFS devices.
          ACFS-9309: ADVM/ACFS installation correctness verified.
          CRS-4402: The CSS daemon was started in exclusive mode but found an active CSS daemon on node ccbsn01, number 1, and is terminating
          An active cluster was found during exclusive startup, restarting to join the cluster
          Failed to start Oracle Clusterware stack
          Failed to start Cluster Synchorinisation Service in clustered mode at /home/oragi/11.2.0.3/grid/crs/install/crsconfig_lib.pm line 1016.
          /home/oragi/11.2.0.3/grid/perl/bin/perl -I/home/oragi/11.2.0.3/grid/perl/lib -I/home/oragi/11.2.0.3/grid/crs/install /home/oragi/11.2.0.3/grid/crs/install/rootcrs.pl execution failed

          below is a part of the ocssd.log

          2012-09-21 20:50:48.088: [    CSSD][1105955136]clssgmDestroyProc: cleaning up proc(0x2aaab007d520) con(0x4a9d) skgpid ospid 13595 with 0 clients, refcount 0
          2012-09-21 20:50:48.089: [    CSSD][1105955136]clssgmDiscEndpcl: gipcDestroy 0x4a9d
          2012-09-21 20:50:48.107: [    CSSD][1105955136]clssgmExecuteClientRequest: MAINT recvd from proc 2 (0x171d6680)
          2012-09-21 20:50:48.107: [    CSSD][1105955136]clssgmShutDown: Received abortive shutdown request from client.
          2012-09-21 20:50:48.107: [    CSSD][1105955136]###################################
          2012-09-21 20:50:48.107: [    CSSD][1105955136]clssscExit: CSSD aborting from thread GMClientListener
          2012-09-21 20:50:48.107: [    CSSD][1105955136]###################################
          2012-09-21 20:50:48.107: [    CSSD][1105955136](:CSSSC00012:)clssscExit: A fatal error occurred and the CSS daemon is terminating abnormally
          2012-09-21 20:50:48.107: [    CSSD][1105955136]clssgmUpdateEventValue: CmInfo State val 0, changes 1
          2012-09-21 20:50:48.369: [    CSSD][1086126400]clssgmWaitOnEventValue: after CmInfo State val 3, eval 0 waited 740
          2012-09-21 20:50:48.369: [    CSSD][1086126400]clssgmPeerListener: terminating at incarn(0)
          2012-09-21 20:50:48.994: [    CSSD][1103698240]clssnmvDHBValidateNCopy: node 1, Noden01, has a disk HB, but no network HB, DHB has rcfg 243706324, wrtcnt, 18304, LATS 12319064, lastSeqNo 18303, uniqueness 1348222449, timestamp 1348240848/20566724
          2012-09-21 20:50:49.849: [    CSSD][1094711616]clssnmSendingThread: sending join msg to all nodes
          2012-09-21 20:50:49.849: [    CSSD][1094711616]clssnmSendingThread: sent 4 join msgs to all nodes
          2012-09-21 20:50:49.997: [    CSSD][1103698240]clssnmvDHBValidateNCopy: node 1, Noden01, has a disk HB, but no network HB, DHB has rcfg 243706324, wrtcnt, 18305, LATS 12320064, lastSeqNo 18304, uniqueness 1348222449, timestamp 1348240849/20567734
          2012-09-21 20:50:51.002: [    CSSD][1103698240]clssnmvDHBValidateNCopy: node 1, Noden01, has a disk HB, but no network HB, DHB has rcfg 243706324, wrtcnt, 18306, LATS 12321074, lastSeqNo 18305, uniqueness 1348222449, timestamp 1348240850/20568744
          2012-09-21 20:50:52.004: [    CSSD][1103698240]clssnmvDHBValidateNCopy: node 1, Noden01, has a disk HB, but no network HB, DHB has rcfg 243706324, wrtcnt, 18307, LATS 12322074, lastSeqNo 18306, uniqueness 1348222449, timestamp 1348240851/20569764
          2012-09-21 20:50:52.852: [    CSSD][1096288576]clssnmRcfgMgrThread: Local Join
          2012-09-21 20:50:52.852: [    CSSD][1096288576]clssnmLocalJoinEvent: begin on node(2), waittime 193000
          2012-09-21 20:50:52.852: [    CSSD][1096288576]clssnmLocalJoinEvent: set curtime (12322924) for my node
          2012-09-21 20:50:52.852: [    CSSD][1096288576]clssnmLocalJoinEvent: scanning 32 nodes
          2012-09-21 20:50:52.852: [    CSSD][1096288576]clssnmLocalJoinEvent: Node Noden01, number 1, is in an existing cluster with disk state 3
          2012-09-21 20:50:52.853: [    CSSD][1096288576]clssnmLocalJoinEvent: takeover aborted due to cluster member node found on disk
          2012-09-21 20:50:53.007: [    CSSD][1103698240]clssnmvDHBValidateNCopy: node 1, Noden01, has a disk HB, but no network HB, DHB has rcfg 243706324, wrtcnt, 18308, LATS 12323074, lastSeqNo 18307, uniqueness 1348222449, timestamp 1348240852/20570764


          Thanks and regards