This content has been marked as final. Show 11 replies
Reboot the node
It would be better if you close this thread and move your thread to this part of forum.
Thanks for your reply,
I am using RHEL 5.4.
Could you post it please
this thread moved to another category i.e. ASM
Just Post what i told you
[root@host1 selinux]# more config
# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
# enforcing - SELinux security policy is enforced.
# permissive - SELinux prints warnings instead of enforcing.
# disabled - SELinux is fully disabled.
# SELINUXTYPE= type of policy in use. Possible values are:
# targeted - Only targeted network daemons are protected.
# strict - Full SELinux protection.
post the log message
I don't know, where was the problem. But when i start my machine today that's working. I am concluding that there are certain things which I further needs to be investigated which may remain untouched or is hidden.
Thanks to all of you for your precious time.