This content has been marked as final. Show 3 replies
There are two things that may help you with this use case:
1. You can model the "waste" as an referenced output product or an internal output. Either of these types will allow you to use it in a formulation step. To maintain formulation balance I would recommend a referenced output product.
2. You can also turn on the range calculation paths. With these calculation paths a min and max percentage field will be available for every formulation input. This will allow you to set a max percentage value. To turn on formulation ranges use the following configuration keys. Once they are turned on you will see new range calculation paths in the formulation path drop down.
- this will turn on min and max percentages while the input percent field is editable
- this will turn on min and max percentages while the input quantity field is editable
- this will turn on min and max percentages while the input yield quantity field is editable
You can learn more about how to manage feature configurations in the configuration guide.
The system prohibits users from using waste as an input into a formulation or a finished good. If it is truly waste then it's waste and is disposed of. If its just waste for that specific process but used again in other formulations then we consider that a product. If its just waste for that specific process but then sold as a finished good we consider that a by-product.