When I run a job in grid control on a windows node that has an ftp task, it sometimes suppresses the output you would normally see at the DOS prompt. Here is the output from grid control:
but does not show the output of the put for the file, e.g.
ftp> put D:\batch\JPay\output\visitor_list_fixed.txt
200 PORT command successful.
150 Opening BINARY mode data connection for visitor_list_fixed.txt.
226 Transfer complete. 4,265,432 bytes transferred. 587.18 KB/sec.
ftp: 4265432 bytes sent in 7.05Seconds 605.28Kbytes/sec.
221 Goodbye, closing session.
Can I stop the output suppression?
i suspect this happens because ftp connection opens a new process and has its own streams for output and error. You can try to pipe the output to a temp file and then cat the output once ftp is completed.