This content has been marked as final. Show 3 replies
Pinela wrote:Its a Good question. While configuring EM it gathers all the information such as hostname, instance name, port number , listener and so many..
I have this scenario:
- Oracle 184.108.40.206
- RHEL 4.6 64 bits
- Active Data Guard
- Broker configured
- DBconsole configured on primary server
Now, I have server PRIM with the primary database, and server STB with the standby server. For now, the dbconsole is configured in the PRIM server.
When I do a switchover (to the standby on STB), EM is not configured, so I use RepManager.sh to clean the sysman user, and I use emca to recreate the dbconsole. After this, everything works.
Once I switch back, the EM is no longer configured on PRIM, so I repeat the previous steps (repManager and emca).
Everything is ok after this. I can access the EM on the primary normaly, and this gets information from the broker to provide basic information on the STB (like db status, apply, and so forth).
my question is this:
- do I have to do all these steps in case of a switchover? is there an easier way?
- would grid control solve this situation?
Of course configuration is not same on primary and standby, then EM configuration file properties mismatch with services after the switchover specifically if you are monitoring redo transport , apply and status so on....
AFAIK, you must reconfigure again whenever there is frequent changes. BTW, reconfiguring EM which takes minutes of time.