This content has been marked as final. Show 6 replies
1) you can take BACKUP of SOURCE database and use RMAN DUPLICATE DATABASE (or) RESTORE method
as you have a shared file system between SOUREC and TARGET servers
2) you can use RMAN DUPLICATE FROM ACTIVE DATABASE
3) Once i used the ASMCMD CP command to copy the datafiles directly to TARGET ASM and recovered it
(it worked even our SOURCE DB is up and running )
I guess you are trying do following:
source: 2-node RAC
Target: 2-node RAC
you create spfile for your TARGET RAC database and nomount the database on one node. No need to worry about other node at this time. All you need to make sure you have correct prameters in the pfile.
connect to auxiliary instance (i.e nomount database on the first node) and run RMAN DUPLICATE command.
once database is up and running, start the instance on other node.
Just note.. 5 TB is a huge volume for DUplicate cmd to handle.. esp if the same network is being used by your production databases.
We once ran a duplicate restore for 1 TB data.. that ate up the entire bandwidth.. ran for hours .. and had to benally killed.. as it was impacting Production Performkance.
yes. you can. you simply need to shutdown one of the nodes (target nodes), alter the init for cluster_database=false, and then do a normal duplicate.
yes, you need an auxiliary, because you are going to be connected to both DBs: target (production) and auxiliary (test).
No problem there.
Regarding time on network. you will only use the network heavily if you run a duplicate from active database.
if you run a normal duplicate, the command uses already existing backup pieces, with minor network communication between the target and auxiliary.
RMAN only connects to get the CF information.
From a recent experience, I duplicated a 4TB database in 23hours with no noticeable burden on production. So you have a baseline.
hope this helps.
Thanks very much.
I dplicated the db between two exadata.
On production exadata, i use rman to backup on zfssa storage. I mount the zfssa by nfs on second (test) exadata.
on second (test) exadata, I create a sample rac database and start nomount only one instance. I start rman and connect to target (production), auxiliary (local test) and catalog.
start simple duplicate command. After 11h dupicate finished and test db works fine.
Thanks and regards.