Error: I cannot enable the standby database from dgmgrl
create configuration 'DGConfigCTT' as primary database is 'cttdb' connect identifier is cttdb; add database 'cttstby' as connect identifier is cttstby;
dgmgrl DGMGRL for Linux: Version 126.96.36.199.0 - 64bit Production Copyright (c) 2000, 2009, Oracle. All rights reserved. Welcome to DGMGRL, type "help" for information. DGMGRL> connect sys Password: Connected. DGMGRL> show database cttstby 'StatusReport'; Error: ORA-16548: database not enabled DGMGRL> enable database cttstby; Enabled. DGMGRL> show database cttstby 'StatusReport'; Error: ORA-16548: database not enabled DGMGRL> DGMGRL> DGMGRL> DGMGRL>
DBA wrote:give results of
Yes, I did enabled it
DGMGRL> show configuration;You should enable configuration , later if you add any database of course your step applicables. Below is sample
Edited by: CKPT on Jan 11, 2013 7:59 PM
DGMGRL> enable configuration; Enabled. DGMGRL> DGMGRL> show configuration; Configuration - CKPT Protection Mode: MaxPerformance Databases: PRIM - Primary database STAND - Physical standby database Fast-Start Failover: DISABLED Configuration Status: SUCCESS DGMGRL>
DBA wrote:You can also see from below documentation, for prerequisites of switchover.
I am wondering whar are the steps to check the dataguard setup before performing a switchover test?
I would need to check everything before perform a switchover test.