This discussion is archived
3 Replies Latest reply: Jan 22, 2013 8:20 PM by 720834 RSS

Listing incident log information using WLST commands

720834 Newbie
Currently Being Moderated
Following this page, I tried to get all the list of incident logs using listIncidents() WLST command.
Inspite of some existing incidents on the 'adr/diag/ofm....incident' directory, the command output nothing.
Could someone point me out if there is any issue with the command.

Here is the console output for WLST command run

wls:/offline> connect('weblogic', 'weblogic1', 't3://')
Connecting to t3:// with userid weblogic ...
Successfully connected to Admin Server 'DefaultServer' that belongs to domain 'DefaultDomain'.

Warning: An insecure protocol was used to connect to the
server. To ensure on-the-wire security, the SSL port or
Admin port should be used instead.

wls:/DefaultDomain/serverConfig> listIncidents()
Incident Id Problem Key Incident Time

Here is the listing actual existing incidents

[vsingava@slc02jtl incident]$ pwd
[vsingava@slc02jtl incident]$ ls -lrt
total 4
drwxr----- 2 vsingava dba 4096 Jan 11 08:45 incdir_1
[vsingava@slc02jtl incident]$


  • Correct Answers - 10 points
  • Helpful Answers - 5 points