I setup solaris 10 on sun M4000 sparc server, every thing is good when install complete I cannot ping to Gateway from Solaris 10 OS, but on XSCF console I can ping to gateway
SPARCM4000# ifconfig -a
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232 index 1
inet 127.0.0.1 netmask ff000000
bge1: flags=1000803<UP,BROADCAST,MULTICAST,IPv4> mtu 1500 index 2
inet 172.16.3.235 netmask ffffff00 broadcast 172.16.3.255
sppp0: flags=10010008d1<UP,POINTOPOINT,RUNNING,NOARP,MULTICAST,IPv4,FIXEDMTU> mtu 1500 index 3
inet 192.168.224.2 --> 192.168.224.1 netmask ffffff00
Any body can help me?
Bellow is command result:
SPARCM4000# ifconfig -a plumb
ifconfig: SIOCSLIFNAME for ip: bge0: already exists
ifconfig: SIOCSLIFNAME for ip: bge1: already exists
SPARCM4000# dladm show-dev
bge0 link: down speed: 0 Mbps duplex: unknown
bge1 link: down speed: 0 Mbps duplex: unknown
when I ping is route to sppp0 gw is not route correct GW
According result of dladm show-dev both cards ( bge0 and bge1) currently disconnected ( link down).
Check all connected cables and port on switch.
Cable to XSCF and cable to domain network - fully undepended.
You require separate cable for connect Solaris to network.
How many Ethernet Cables connected to you server and what ports ?
XSCF has its own ethernet connections.
Solaris Domain have separate own connections.
Do you have ethernet cable connected to I/O Unit ?
Docs index about M4000:
I have 2 Ethernet cables connected to server on ETHERNET 0 and ETHERNET 1 ports.
Sorry I don't clear about port solaris not use the same Ethernet with xscf? and how should I can config?
Sorry about the basic question.
Thanks and regards
You should remove cable from XSCF ethernet1 and connect this cable to port 1 of I/O unit.
( Two ethernet ports below PCI slots )
Page 8 Figure 3.
Use one ethernet port NOT on XSCF !
XSCF - separated computer for monitoring and manage server.
bge0; bge1 - Separated Ethernet port on I/O Unit available at Solaris Domain.
You already configure it at solaris, but not connect cable to it.