Hi I have 2 V490's which ive configured for RSC and everything looks good, ive confirmed I can telnet onto the RSC card by attaching a X-over from my laptop to the RSC card and and confirmed I can access the RSC and go to the ok> prompt etc etc.
My problem is when I try to telnet to the RSC port from a terminal server or server on the same subnet I am unable to see anything except a blank screen, I can hit enter and something comes back but am unable to get to any RSC prompt.
Ive installed RSC 2.2.3 and am running Solaris10.
-bash-3.2# */usr/platform/SUNW,Sun-Fire-V490/rsc/rscadm show*
escape_char="~" EEPROM output
Thanks in advance for any thoughts...
If you can access the RSC Shell from the ok prompt, there should not be any problem with the RSC itself.
You may check again the network settings that you have applied to the RSC or any firewall settings which may block the port 23 for telnet.
Couple of questions,
* Do you have ping to the RSC from the terminal server???
* Check the IP address is the same. ( the one you see in Solaris and in the RSC card)
* Did you reboot the RSC card???
felipe@mar mar 26:~$ ping 10.5.5.5
PING 10.5.5.5 (10.5.5.5) 56(84) bytes of data.
64 bytes from 10.5.5.5: icmp_req=1 ttl=64 time=1.34 ms
64 bytes from 10.5.5.5: icmp_req=2 ttl=64 time=1.04 ms
Note: the RSC supports a maximum of 2 telnet connections.
Edited by: fgutierrez on Mar 26, 2013 2:31 PM
Edited by: fgutierrez on Mar 26, 2013 2:32 PM