I read in the documentation that this interfaces default state is set to enabled, however, it is not.
The following command was ran from serial connection. In an attempt to turn on the interface.
It returns "set: command failed".
Oddly enough running the command to disable the interface "set state=disabled" seems to succeed. Its output is as follows.
"Set 'state' to 'disabled'"
This is a brand new Sun Server X3-2(Sun Fire x4170 M3)
Does anyone know what I am doing wrong here?
I'll also note that if you setup the interface from Oracle System Assistant it will work, but that is an extremely long a tedious process compared to using the com port.
Thanks for reading!
I figured it out.
This was due to ipv6 being set enabled.
Then I could go back to /sp/network/ and enable the interface and configure it.
Sorry, guess I just needed a second to think. Sometimes Google doesn't have the answer.