I installed the Address verification in the location C:\Program files\EDQAV\data,also installed the loqate software in the loacation C:\Program files\loqate.
Configured the av file where it is present in the config folder.I gave loqate.dir=C:\Program files\EDQAV\data and for loqate.jar=C:\Program files\EDQAV\loqate.jar.
After configuring i tried tested with data the Address verification.The result has av.Accuracycode,av.country etc as blank and av.result as 0.
Please may i know where i am going wrong.
Thanks & Regards,
There look to be a few problems there.
First, your path to the jar file is wrong, as you have installed it in Program Files/loqate but have referred to it in Program Files/EDQAV.
Also you need to use the right property names in av.properties, and use two backslashes for the Windows paths, e.g.:
Then make sure the path to the software directory (C:\Program Files\loqate in your case) is on your system path. And make sure you are running EDQ with the same architecture (32 or 64 bit) as EDQ AV.
Please follow the AV Installation instructions http://www.oracle.com/technetwork/middleware/oedq/edqav1331install-2052479.pdf, and use the troubleshooting section if needed.