0 Replies Latest reply on Jul 20, 2014 6:08 AM by 2631549

    FDM workbench client login error-Dev server


      Hi All,


      I have post configured the fdm components after the installation and configuration is completed and when i try to connect the fdm workbench client to create application from there i am getting following error


      Microsoft Software installer error was encountered --- what is this error and how rectify it please let me know i have checked 32 and 64 bit client is installed correctly in the server where fdm is configured


      Few guys advised that to check DCOM config for FDM entries RUN-->Dcomconfg--->DCOM. here what i have to check for FDM entries and how i have to enter please advise in clearing issue