Malformed pdf after installing ORDS 18.2 (FOP 2.2) causes pdf XSLT1

mdehaan Sep 7, 2018 11:25 AM

We have created an application in APEX that creates PDF-files using an XSLT1.0 stylesheet, created with Altova Stylevision.

Since I have installed ORDS 18.2.0 this PDF files shows slightly different and I assume this is caused by the fact that ORDS has been upgraded to FOP 2.2.

Is the FOP-version related to the XSLT-version?

Is it possible that my PDF is OK again when I save my stylehseet to XSLT2.0 or are these version-numbers not related to each other at all?

All response is greatly appreciated.

Thanks in advance.

Marco

1. Re: Malformed pdf after installing ORDS 18.2 (FOP 2.2) causes pdf XSLT1

MiroMas Sep 25, 2018 1:20 PM (in response to mdehaan)

Version numbers are not related. FOP works like: XML --XSL-FO--> XML-FO --FOP processor--> PDF.
You created XSL-FO with Altova, so only diference is inside FOP processor. FOP processor transforms XML-FO to binary PDF. New FOP processor (ver 2.2.) is probably reason of change.

HTH
Miro
1 person found this helpful
Like Show 1 Likes(1)

Actions
2. Re: Malformed pdf after installing ORDS 18.2 (FOP 2.2) causes pdf XSLT1

MiroMas Sep 27, 2018 2:20 PM (in response to MiroMas)

Please mark answer as helpfull if you feel so.

Regards
Miro
Like Show 0 Likes(0)

Actions

Go to original post