This content has been marked as final. Show 4 replies
Has anyone resolved this problem?
I've ran into the same problem using 9.1 on RH7.3. Here is some more information:
On two of my tables, I have one BLOB column. Reading and writing those columns seems to cause no problems at all.
However, one table has two BLOBs. I have no problems reading, but the first write (updating both columns) causes the next select to fail. Actually, I must disconnect at this point.
I am no expert, but I found this reponse on another web site to the exact same error we are having...
"The SDU is a buffer that Net8 uses to place data before transmitting across the
network. Net8 sends the data in the buffer either when requested or when it is full.
The SDU size should be set as a multiple of the normal transport frame size. Since
the normal Ethernet frame size is 1024, the most efficient SDU size over an
Ethernet protocol should be a multiple of 1024, but not more than four times the
amount of 1024.
try stripping the settings out all together first"