ST2530 degraded cannot create volume in default pool.
edited Jun 30, 2013 11:43PM in Disk Storage 2000, 3000, 6000 RAID Arrays & JBODs (MOSC) 3 commentsAnswered ✓
Hi all,
On a ST2530, i have a broken disk.
The 5 disks volume is in degraded condition.
I have successfully removed some volumes.
But I can't create new ones.
If I go on ST2530 tab, I have.
Name : ST2530
Health : Degraded
Type 2530
Version of firmware is 07.35.44.10
Total Capacity : 1.364 TB
Available Capacity : 570.587GB
On Pools tab
Name Default
Storage profile : Default
State : In Use
Used Percent 48%
Total Capacity 1.089TB
Configured Capacity : 545 GB
Available Capacity 0
Is this available capacity due to degraded mode ?
If I select volumes tab, and new, it never propose default pool.
Shall I have to clear the disk problem prior to create new volumes ?
On a ST2530, i have a broken disk.
The 5 disks volume is in degraded condition.
I have successfully removed some volumes.
But I can't create new ones.
If I go on ST2530 tab, I have.
Name : ST2530
Health : Degraded
Type 2530
Version of firmware is 07.35.44.10
Total Capacity : 1.364 TB
Available Capacity : 570.587GB
On Pools tab
Name Default
Storage profile : Default
State : In Use
Used Percent 48%
Total Capacity 1.089TB
Configured Capacity : 545 GB
Available Capacity 0
Is this available capacity due to degraded mode ?
If I select volumes tab, and new, it never propose default pool.
Shall I have to clear the disk problem prior to create new volumes ?
0