Cycle Count task does not complete
Question: Why does the Cycle count task remain in READY status even after task is done in the RF? Shouldn't it be updated to COMPLETED?
Steps done as follows:
- Task Template is run.
- Task is created.
- Task is released. Current status = READY; Task Type = CC Location LPN Scan
- RF is launched. Went to Inventory > Cycle Count > CC LPN Scan - Reserve
- Process task as usual. Scan Location > Receive a message "Cycle Count Task Open for the Location Do you wish to proceed with the count? > Accept > Scan LPNs > End Location Count
- Went back to Task UI screen. Found that status remain in READY status.
Tagged:
0