IPSA: Cisco IOS switch ME4900

 Hi,

We're adding the ME4900 switch into our layer 2 network. This device is the first IOS switch we have used which uses a 10Gig interface. As part of our service activation, we will need to apply some interface specific commands. We haven't determined exactly which ones we will require. But we're interested in which of the following commands which can be applied are supported by the ISPA Cisco IOS cartridge:

tlab-s-061(config)#int tenGigabitEthernet 1/30 tlab-s-061(config-if)#? Interface configuration commands:   access-group        Access group configuration   arp                 Set arp type (arpa, probe, snap) or timeout   auto                Configure Automation   backup              Modify backup parameters   bandwidth           Set bandwidth informational parameter