Receipt Routing to mulitple locations doesn't close PO
We're in the middle of an XE to 9.0 upgrade, and have run into a stumbling block with receipt routing that was hoping somebody could provide some guidance.
Typically, we receive the full quantity into routing, and when the final receipt to STK occurs, if there are no issues with inventory, the full quantity is received to the single standard location. When this happens, it closes the PO line, in both XE and 9.0, as expected.
If there are any issues with inventory, they will receive the "good" quantity to the standard location, and then any questionable inventory to a "hold" location for further review. While at the inventory level, this appears to be working fine, in XE this would also close the PO line as expected, but in 9.0 it is leaving the line open. I'm almost 100% certain that our set up and configuration is consistent across the two environments, and I'm not even sure of a setting that would cause this.
Typically, we receive the full quantity into routing, and when the final receipt to STK occurs, if there are no issues with inventory, the full quantity is received to the single standard location. When this happens, it closes the PO line, in both XE and 9.0, as expected.
If there are any issues with inventory, they will receive the "good" quantity to the standard location, and then any questionable inventory to a "hold" location for further review. While at the inventory level, this appears to be working fine, in XE this would also close the PO line as expected, but in 9.0 it is leaving the line open. I'm almost 100% certain that our set up and configuration is consistent across the two environments, and I'm not even sure of a setting that would cause this.
0