Unable to access Integration Settings within FDQM Workbench - Error dialog appears
edited Feb 19, 2012 1:32AM in Hyperion Financial Data Quality Management (FDM/FDMEE) (MOSC) 7 comments
I am receiving a dialog window that pops up when I try to access the Integration Settings within the Workbench. The dialog says:
This action cannot be completed because the other application is busy. Choose "Switch To" to activate
the busy application and correct the problem.
Below this are 3 buttons
"Switch To"
"Retry"
Cancel (This one is grayed out)
Nothing happens when I click either of the buttons. The dialog just goes away and then comes right back.
We are using one server for FDQM. Version 11.1.1.3. Target Adapter I imported and registered is Essbase / Planning if that matters.
This is my first application I am setting up after going through training. I hope I am not doing anything wrong. Even if I were I should be able to see the parameters / settings for the integration.
This action cannot be completed because the other application is busy. Choose "Switch To" to activate
the busy application and correct the problem.
Below this are 3 buttons
"Switch To"
"Retry"
Cancel (This one is grayed out)
Nothing happens when I click either of the buttons. The dialog just goes away and then comes right back.
We are using one server for FDQM. Version 11.1.1.3. Target Adapter I imported and registered is Essbase / Planning if that matters.
This is my first application I am setting up after going through training. I hope I am not doing anything wrong. Even if I were I should be able to see the parameters / settings for the integration.
0