rpool became unbootable after replacing raid HBA (SGX-SAS6-R-INT) on T3-1 platforms
Hi Experts,
The issue is resolved yet but I'd like to understand why this problem was caused because it seems this is not one off issue.
Would you tell me why this issue is caused and if the issue can happen just on SPARC T3-x/T4-x platform with SGX-SAS6-R-INT, or we have the same risk on another platform or raid controller.
## just FYI, following two conditions were verified not cause this problem.
## - T3-1 + SGX-SAS6-R-INT using ufs/Solaris 10 boot
## - Netra X4270 + SGX-SAS6-R-INT using both rpool and ufs/Solaris 10
below is the operation what I did when I experienced panic reboot issue.
The issue is resolved yet but I'd like to understand why this problem was caused because it seems this is not one off issue.
Would you tell me why this issue is caused and if the issue can happen just on SPARC T3-x/T4-x platform with SGX-SAS6-R-INT, or we have the same risk on another platform or raid controller.
## just FYI, following two conditions were verified not cause this problem.
## - T3-1 + SGX-SAS6-R-INT using ufs/Solaris 10 boot
## - Netra X4270 + SGX-SAS6-R-INT using both rpool and ufs/Solaris 10
below is the operation what I did when I experienced panic reboot issue.
0