Zpool issue / clear error after hardware replacement
One of four disk was failed on my sparc T4-1 on which raid1E
And i replaced it (hot plug as is hardware raid ); but the first disk used to make this replacement not synchronize well. Then I used another disk again which is synchronized well. Every disk LED is on green and zpool becomes Online also.
At the end of the replacement when run the following command , see their output below:
- 1- Under ILom
-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y
faultmgmtsp> fmadm faulty
(No faullt found)
- 2-