Replace device in SUSPENDED pool
Hi.
Recently I've made stupid move.
On My pool I've attached devices (mirrored pool, but new devices were not mirrored) that were about to be removed. Probably is was brain-dead for a few seconds.
Now pool in n SUSPENDED state. I can only read from this pool, so the situation is not that dramatic at this point.
Because pool is suspended I'm getting I/O error on every operation on this pool. (RLY?)
pool: data
state: SUSPENDED
status: One or more devices are unavailable in response to IO failures.
The pool is suspended.
action: Make sure the affected devices are connected, then run 'zpool clear' or