Breaking the bond on X7-2 Bare Metal is Only supported in 12.2.1.3.0 forward + Run FIRSTNET BEFORE t

if you want to break the bond for the X7-2 HA

- Please read ALL of these steps before attempting to break the bond or you will have to re-image

1) You must deploy the ODA on 12.2.1.3
2) Breaking the bond is only supported on Bare Metal + X7-2 HA + 12.2.1.3 at this time

2) Before deploying you must run FIRSTNET on each node
3) The step to break the BOND is only possible during the FIRSTNET option shown below:

# configure-firstnet

Using bonding public interface (yes/no) [yes]: no           <<

INFO: Breaking the bonding on btbond1

INFO: remove bonding module: rmmod bonding

...

• ODAVP X7-2 HA does not support breaking the bond ( you should not see the above as an option using 12.2.1.3 FIRSTNET)