In Failure Analysis do you only have the option to set them up against Asset Groups? We have had a r

I’m looking at the ‘Failure Analysis’ and trying to setup a
trial within TST2 but I have an issue where the ‘Asset Group’ ‘Point Op Equip’
contains 3 different types of Points which will each require their own fault
codes.

Adding all options for the 3 types will mean the techs will
have to wade through lots of irrelevant options and will probably result in the
wrong option being chosen – see screen snippet below

A couple of questions, if I may

• Is there an option to apply fault codes to the
       ‘Category’ level?
• Assuming the answer to above is “No”, can we rename the