Subscriber-aware Load Balancer

Hello,

I need to bring it to service and the SBC reports 'LostControl', the SLB 'show balancer tunnels' returns an empty response and there's this record in the log:

Jul 12 07:55:23.718 [MINOR] (0) initial_setup: No Profile for DTLS Socket 10.4.13.70:4444

Jul 12 07:55:23.718 [SERVICE] (0) ClusterSocket CCD/10.4.13.70:4444: Bind to 10.4.13.70:4444 handle=130 addr=10.4.13.70:4444 failed, err=99 Cannot assign requested address reconn t=10000

Jul 12 07:55:23.718 [SERVICE] (0)   ClusterSocket CCD/10.4.13.70:4444

SBC tunnel facing interface:

network-interface

        name                                    M10

        ip-address                              10.4.14.71

        netmask                                 255.255.255.0

        gateway                                 10.4.14.70

        tunnel-config

                name                                    SBC1

                local-ip-address                        10.4.13.60

                remote-ip-address                       10.4.13.70

                application                             SIP

                traffic-policy                          default

SLB tunnel facing interface:

network-interface

        name                                    M10

        tunnel-config

                local-ip-address                        10.4.13.70

Do I have to configure SBC's IP/mask/gw for the M10 network-interface too or is this ok?